Changelog of DAMC-FMC2ZUP MMC
V2.04

    Update docs

V2.03

    Add reg.dump, stack dump & backtrace on watchdog reset

V2.02

    Make MCH show_fru show product name from FRU
    Fix manual fru_start/shutdown from MCH

V2.01

    Fix manual fru_start/shutdown from MCH

V2.00

    Migrate to new CPLD regmap
    Add support for FMC PG, HSPC, CLK_DIR signals
    Include PS_ERROR/PS_STATUS in status info

V1.21

    Add support for FMC sensors
    Improve IPMI latency
    Fix CPLD error on reset
    Misc RTM fixes and improvements
    Add support for FRU FmcI2cDeviceDefinition
    Support RTM handle in out-of-crate mode
    Add RTM Isens calibration

V1.20

    Fix CPLD error (0xff) on reset

V1.19

    Skip Z3_DRV_EN when 12V not enabled

V1.18

    Make show_fru on MCH show the actual name of the RTM
    Improve IPMB debug logging

V1.17

    Fix detection of unprogrammed power manager
    Include Stamp UID in version info & boot msg

V1.16

    Fix FRU ID in RTM device locator

V1.15

    Add support for MDI variant w/o Z3 PLL
    Avoid PCA9574 errors when booting w/ 12V enabled
    Wait for AMC powerdown seq finished before retrying
    Don't probe FMC EEPROM if FMC module not present
    Add eefd - set EEPROM to factory defaults

V1.14

    FMC: Add support for 32k EEPROM at different address
    FMC: Add support for optional GA-swapped fallback EEPROM addresses
    CPLD: Fix errors when rebooting w/ 12V enabled

V1.13

    Update CPLD to 7.2; fixes swapped interlock lines
    Fix wdg bootloop in case of blocked FMC I2C bus
    Fix wdg reset when i2cd operates on blocked bus
    Restrict RTM UID and DAC access to DESY RTMs
    Add ppf command (set payload power fail policy)
    Fix FRU parser for longer part_no strings
    Fix FPGA INIT & DONE readout
    Detect unprogrammed power manager

V1.12

    Add support for FMC sensors
    Fix CPLD auto-update on unprogrammed boards
    Add support for SPI flash update
    Add i2cget/set commands

V1.11

    Add DRTM-PZT4 compatibility mode
    Fix assignment of DC/DC temperature sensors

V1.10

    Fix MCH warnings / fail LED / power cycle in bootloader mode

V1.09

    Update CPLD (fix "stuck at boot")

V1.08

    Fix redundant decimal places on NAT sensor display

V1.07

    Fix rounding errors in sensors coefficients
    Fix I_RTM sensors increments
    Force I_RTM readings to zero if RTM off

V1.06

    Add R/W support for FMC EEPROMs
    Add FMC EEPROM addr. width auto-detection
    Fix PLL startup delay issue
    Add support for out-of-crate mode

V1.05

    Fix "Z3 compatibility" FRU parsing
    Fix channel name VCC_1V8 -> VCC_1V8A
    Fix SI5340 console message

V1.04

    Fix watchdog reset loop in case of unprogrammed powermanager

V1.03

    FRU write verify, fix corrupt AMC FRU

V1.02

    Wait for shutdown complete, when handle is pulled. Keep 12V PP, until PSM has gracefully shut down.

V1.01

    PSM orderly shutdown on pmc write|verify command

V1.00

    Change Jenkins build to use recent CPLD interface (with EFB)

V0.18

    Last version using "legacy CPLD" as default build (-DCPLD_NO_EFB=1)
    Support in-application update of CPLD
    Support IMON channels for current monitoring
    Support PMBUS configuration from MMC
    Use PMBUS commands instead of GPIO to switch payload pwr

V0.17

    preliminary version w/ FMC & RTM e-keying

V0.16

    Implement FMC Vadj & ZUP Vcore setting

V0.15

    Add support for updating the bootloader

V0.14

    Intermediate version

V0.13

    Initial version w/ libdmmc