3.1. Basic Commands
In this section the commands used to turn ON or OFF the power unit, change its setpoint, read the voltage, current, power etc are listed.
Table of Contents
- 3.1.1. VER Command
- 3.1.2. ID Command
- 3.1.3. LOOP Command
- 3.1.4. UPMODE Command
- 3.1.5. FLOATMODE Command
- 3.1.6. OUT Command
- 3.1.7. SET Command
- 3.1.8. GET Command
- 3.1.9. REG Command
- 3.1.10. LIMITS Command
- 3.1.11. TEMP Command
- 3.1.12. UPFREQ Command
- 3.1.13. INTERLOCK Command
- 3.1.14. SWITCH Command
- 3.1.15. CROWBAR Command