3. Commands
In this chapter the power supply commands with its description are listed.
Note
Every command should be followed by the termination sequence CRLF
\r\n
.The replies from the power source are also terminated with the same sequence CRLF
\r\n
.
Warning
In the next examples the termination sequence will be not be shown for a better readability of the code.
Table of Contents
- 3.1. Basic Commands
- 3.1.1. VER Command
- 3.1.2. ID Command
- 3.1.3. LOOP Command
- 3.1.4. UPMODE Command
- 3.1.5. FLOATMODE Command
- 3.1.6. OUT Command
- 3.1.7. SET Command
- 3.1.8. GET Command
- 3.1.9. REG Command
- 3.1.10. LIMITS Command
- 3.1.11. TEMP Command
- 3.1.12. UPFREQ Command
- 3.1.13. INTERLOCK Command
- 3.1.14. SWITCH Command
- 3.1.15. CROWBAR Command
- 3.2. Memory Related Commands
- 3.3. Advanced Commands