2. Commands

In this chapter are listed the power supply commands with its description.

Note

• Every command should be followed by the termination sequence CRLF \r\n.

• The replies from the power source are also terminated with the same sequence CRLF \r\n.

Warning

In the next examples the termination sequence will be not shown for a better readability of the code.

Contents:

• 2.1. Common Commands
  • 2.1.1. VER Command
  • 2.1.2. ID Command
  • 2.1.3. LOOP Command
  • 2.1.4. UPMODE Command
  • 2.1.5. FLOATMODE Command
  • 2.1.6. OUT Command
  • 2.1.7. SET Command
  • 2.1.8. GET Command
  • 2.1.9. REG Command
  • 2.1.10. LIMITS Command
  • 2.1.11. TEMP Command
  • 2.1.12. UPFREQ Command
  • 2.1.13. INTERLOCK Command
  • 2.1.14. SWITCH Command
• 2.2. Memory Related Commands
  • 2.2.1. MEM Command
  • 2.2.2. PASSWORD Command
• 2.3. Advanced Commands
  • 2.3.1. TRIGGER Command
  • 2.3.2. WAVE Command