2.1. Common Commands

In this section are listed the command that can be used to turn ON or OFF the power unit, change its setpoint, read the voltage, current, power etc.

Contents:

• 2.1.1. VER Command
• 2.1.2. ID Command
• 2.1.3. LOOP Command
• 2.1.4. UPMODE Command
• 2.1.5. FLOATMODE Command
• 2.1.6. OUT Command
• 2.1.7. SET Command
• 2.1.8. GET Command
• 2.1.9. REG Command
• 2.1.10. LIMITS Command
• 2.1.11. TEMP Command
• 2.1.12. UPFREQ Command
• 2.1.13. INTERLOCK Command
• 2.1.14. SWITCH Command