3. Commands

In this chapter the power supply commands with its description are listed.

Note

• Every command should be followed by the termination sequence CRLF \r\n .

• The replies from the power source are also terminated with the same sequence CRLF \r\n .

Warning

In the next examples the termination sequence will be not be shown for a better readability of the code.

Table of Contents

• 3.1. Basic Commands
  • 3.1.1. VER Command
  • 3.1.2. ID Command
  • 3.1.3. LOOP Command
  • 3.1.4. UPMODE Command
  • 3.1.5. OUT Command
  • 3.1.6. SET Command
  • 3.1.7. GET Command
  • 3.1.8. REG Command
  • 3.1.9. LIMITS Command
  • 3.1.10. TEMP Command
  • 3.1.11. UPFREQ Command
  • 3.1.12. INTERLOCK Command
• 3.2. Memory Related Commands
  • 3.2.1. MEM Command
  • 3.2.2. PASSWORD Command
• 3.3. Advanced Commands
  • 3.3.1. TRIGGER Command
  • 3.3.2. WAVE Command