6.1. Status Register

The Status Register indicates the unit’s status. To read it, see the REG Command.

Bit(s)	Field	Description	Note
[1:0]	Module status	00: OFF	see OUT Command
		01: ON
		11: Wait for On
[2]	Fault bit	Fault state	see Fault Register
[3]	Reserved	-
[4]	Loop mode	0: CC	see LOOP Command
		1: CV
[6:5]	Reserved	-
[7]	PID Limitation bit	PID is in saturation	The device output current/voltage is limited
[9:8]	Update mode	00: Normal	see UPMODE Command
		10: Waveform
[11:10]	Reserved	-
[12]	Local mode [1]	0: Remote	Local display commands are rejected
		1: Local	Only local display commands are accepted
[15:13]	Reserved	-
[18:16]	Trigger mode	000: Trigger disabled	see TRIGGER Command
		001: Pos. Edge
		010: Neg. Edge
		011: Both Edges
		100: High Level
		101: Low Level
[20:19]	Reserved	-
[21]	Ramping	A ramp is performing
[23]	Reserved	-
[24]	Waveform execution	A waveform is performing
[26:25]	Waveform mode	00: Start	see WAVE Command
		01: Point
		10: Gate
		11: Gate reset
[27]	Reserved	-
[31:28]	Reserved	-

[1]

Local/Remote mode can be only set from the local display menu.

See also

Please see the User’s Manual for more details.