3.1. Basic Commands

In this section the commands used to turn ON or OFF the power unit, change its setpoint, read the voltage, current, power etc are listed.

Table of Contents

• 3.1.1. VER Command
• 3.1.2. ID Command
• 3.1.3. LOOP Command
• 3.1.4. UPMODE Command
• 3.1.5. OUT Command
• 3.1.6. SET Command
• 3.1.7. GET Command
• 3.1.8. REG Command
• 3.1.9. LIMITS Command
• 3.1.10. TEMP Command
• 3.1.11. UPFREQ Command
• 3.1.12. INTERLOCK Command