3.2. Memory Related Commands

The following commands can be used to read and write the Memory parameters, that are stored in the non-volatile memory (disk). The write-access to several parameters is password protected. To modify these parameters, it is necessary to have the admin privileges, that can be obtained using the PASSWORD Command (see {ref}`PASSWORD Command`).

Certain parameters (such as calibration parameters etc.) are read-only, therefore not editable, since they are factory defined.

To read or write the memory parameters use the MEM Command.

The memory parameters are listed on the following page: Internal Memory.

Table of Contents

• 3.2.1. MEM Command
• 3.2.2. PASSWORD Command