GET Command
Applies to: DLOG-OSC modes only; rejected in DMM mode with NAK:5.
The purpose of the GET command is to read back a single actual measured
current. The returned data depends on the selected operation mode and on the
relative output data frequency.
The format of the returned measurement is always expressed as an ASCII
floating point number with 7 decimal digits, in Ampere [A], terminated
by \r\n.
Command Format:
R/W |
Command |
Response |
Description |
|---|---|---|---|
R |
|
|
Get the current reading in Amps |
Note
GET does not require the acquisition to be started with
ACQ:ON: the command itself starts a single
acquisition and returns its result.
Example(s):
MODE:?
DLOG
GET
-14.1234567
MODE:?
DMM
GET
NAK:5