Commands

The CT-BOX commands are grouped by purpose. The mode(s) of operation in which each command applies (see MODE and Modes of Operation) are stated at the top of each command page and in the Mode column of the Command Table Summary.

Most settings can be written and read in any mode, and take effect only in the mode(s) in which they apply. Only GET and ACQT are rejected outside their modes.

• Mode and Acquisition – MODE, ACQ, PRINT.

• Reading – GET, GETA, GETT.

• Output Data Rate and Acquisition Settings – TS, FREQ, DMM, ACQT.

• Measurement Setup – PTURNS, OFFSET.

• Alarm and Trigger – ALARM, TRG.

• SD Card – SD, SAVE.

• Real-Time Clock – DATE, TIME.

• Network – IP, MASK, GATE, PORT.

• Device Information and Reset – VER, CTBOX, DCCT, HWRESET.

• Status and Errors – STATUS, ERR.

• Calibration (Password Protected) – PASSWORD, SCALE, GAIN.

A quick-reference Command Table Summary listing every command and its parameters is also provided at the end of this chapter.